This Waterway Viper hot tub pump is the largest standard pump that Waterway offers for hot tubs. It’s not the HP that makes it the biggest, it’s the wet end with it’s 2-1/2″ intake and discharge that make it bigger than the Executive series and also the Gallons Per Minute of water it can pump
The Waterway Viper hot tub pump is only suitable to replace an existing Viper pump due to the high volume of water it pumps per minute GPM
Features
-
Viper wet end designed specifically for 56-frame motors.
-
Two double shielded ball bearings with moisture resistant grease for quieter operation and longer life.
-
56-frame motor for added strength, cooler operating temperature and longer motor life.
-
Large 2 1/2″ intake and discharge for improved flow performance and reduced noise.
-
Large 8″ diameter wet end for increased volume capacity. Split capacitor, (start and run) for less energy consumption.
-
Thermally protected to extend life expectancy of motor.
-
Highly versatile wet end can be rotated ever 90 degrees.
-
Viton seals.
-
230 Volt
-
Amp highest 16.4 lowest 4.8
Viper installation guide
Viper Safety and troubleshooting